User's Manual

3 Commissioning
Page 17
3.1.2. Wall-Mounting Procedure
 Check the suitability of the wall-mounting kit and the wall.
 Remove the protective cover from the top of the Remote Unit by pulling it
strongly to the front.
 Mark the position of the drilling
holes (for exact measurements
refer to the wall mounting plan
that is part of the delivery). Drill
three holes at the marked
positions and insert dowels*.
 Choose the screw type you
want to use: two possible sets
are provided in the kit; for
details see mounting plan.
 Screw two screws with the
according washers / nuts into
the two upper dowels but do not
fasten them.
 Hang the Remote Unit with the
two upper holes into the upper
screws and, then, fasten them
tight using an appropriate tool.
figure 3-1 Wall mounting
* The dowels are not part of the delivery since the suitable type depends on the on-site conditions
(material of wall). Therefore, use dowels that are appropriate for the mounting surface.
 Then, put the third screw with the according washers / nuts through the bottom
hole of the Remote Unit and screw it into the third dowel using an appropriate
tool.
 Put the protective cover back on top of the Remote Unit.
 Ensure that there is free access to the electrical connections as well as to the
cabinet. The approved bending radius of the connected cables must not be
exceeded.
Bottom hole
Upper holes
Protective cover
Pull strongly!