Installation Instruction

1.3. HEALTH AND SAFETY WARNINGS

1. Danger: Obey all general and regional installation and safety regulations relating to work on high

voltage installations, as well as regulations covering correct use of tools and personal protective

equipment.

2. Danger: Before opening the unit, disconnect mains power.

3. Danger: Laser radiation! Do not stare into the beam; do not view it directly or with optical

instruments.

4. Danger: Due to power dissipation, the remote unit may reach a very high temperature. Do not

operate this equipment on or close to flammable materials. Use caution when servicing the unit.

5. Warning: Read and obey all the warning labels attached to the unit. Make sure that all warning

labels are kept in a legible condition. Replace any missing or damaged labels.

6. Warning: It is the responsibility of the network provider to implement prevention measures to avoid

health hazards associated with radiation from the antenna(s) connected to the unit.

7. Warning: Make sure, access is restricted to qualified personnel.

8. Warning: Only license holders for the respective frequency range are allowed to operate this unit.

9. Warning: Make sure the repeater settings are correct for the intended use (refer to the manufacturer

product information) and regulatory requirements are met.

10. Warning: Use this equipment only for the purpose specified by the manufacturer. Do not carry out

any modifications or fit any spare parts, which are not sold or recommended by the manufacturer.

This could cause fires, electric shock, or other injuries.

11. Warning: For installations which have to comply with European EN50385 exposure compliance

requirements, the following Power Density limits/guidelines (mW/cm²) according to ICNIRP are

valid:

o 0.2 for frequencies from 10 MHz to 400 MHz

o F (MHz) / 2000 for frequencies from 400 MHz to 2 GHz

o 1 for frequencies from 2 GHz to 300 GHz

12. Warning: For installations, which have to comply with FCC RF exposure requirements, the antenna

selection and installation must be completed in a way to ensure compliance with those FCC

requirements. Depending on the RF frequency, rated output power, antenna gain, and the loss

between the repeater and antenna, the minimum distance D to be maintained between the antenna

location and human beings is calculated according to this formula:

]/[

][

cmmW





