User's Manual

3. Commissioning
MF0145ASA.docx User’s Manual for ION
®
-M7HP/85HP EU Page 19
3.1.5. Pole Mounting
The following mounting hardware is required for pole mounting:
figure 3-4 Pole-mounting kit
 Note: The screw bands illustrated above are equipped with quick-release
snaplock clamps which must be disengaged to be applied. The swivel-
action locking of screw to band makes installation and removal fast and
easy.
 Use the 3 screw bands with clamps to fasten the two mounting brackets to the
pole. Use 2 screw bands fitting next to each other on the upper side and 1 screw
band on the lower side.
 Note: When fastening the mounting brackets make sure that they are installed
congruently and not at an angle to each other. To determine the distance
between the beams, refer to the wall/ pole mounting plan that is part of the
delivery.
 Hang the unit into the hooks of the upper mounting bracket and screw the unit to
the lower mounting bracket.
Ensure that there is free access to the electrical connections as well as to the
cabinet. The approved bending radius of the connected cables must not be
exceeded.
Wall/Pole
mounting
brackets
Screw bands
(stainless
steel)
M8.0x25
hexagon
head
screws
Split-lock washers
Plain
washers
for M8.0