User's Manual

6. Connect the mains cable to the
clamps (part of the delivery)
provided at the external alarm
input/ output connector block
located at the application board in
the interior of the RU.
For more detailed information on the external alarm inputs and outputs please refer
to chapters 4.5.1 External-Alarm Inputs and Outputs and 4.5.2 Layout and
Connector Description.
Application board
Page 29 MF0145A8A_FCC modif.doc
3.3. COMMISSIONING
Read the health and safety warnings in chapter 1.2 as well as the description
carefully to avoid mistakes and proceed step by step as described!
 Do not operate the Remote Unit without terminating the antenna connectors.
The antenna connectors may be terminated by connecting them to their
respective antennas or to a dummy load.
 Only qualified personnel should carry out the electrical, mechanical,
commissioning and maintenance activities that require the unit to be powered
on when open.
 When opening the Remote Unit do not damage the warranty labels on the
internal devices. The warranty is void if the seals are broken.
 Ensure that all connections have been performed according to chapter 3.2.2
Connections.
Connecting clamps of external alarms