Installation Instruction

8. Note for a Class A digital device or peripheral:
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
9. For installations which have to comply with Europe an EN50385 exposure compliance requirements,
the following Power Density limits/guidelines (mW/cm²) according to ICNIRP are valid:
o 0.2 for frequencies from 10 MHz to 400 MHz
o F (MHz) / 2000 for frequencies from 400 MHz to 2 GHz
o 1 for frequencies from 2 GHz to 300 GHz
10. Make sure, access is restricted to qualified personnel.
11. Only licence holders for the respective frequency range are allowed to operate this unit.
12. Corresponding local particularities and regulations must be observed. For national deviations please
refer to the respective documents included in the manual CD delivered.
13. Use this equipment only for the purpose specified by the manufacturer. Do not carry out any
modifications or fit any spare parts which are not sold or recommended by the manufacturer. This
could cause fires, electric shock or other injuries.
14. Due to power dissipation, the repeater may reach a very high temperature. Do not operate this
equipment on or close to flammable materials.
15. Before opening the unit, disconnect mains.
16. ESD precautions must be observed! Before commencing maintenance work, use the available
grounding system to connect ESD protection measures.
17. This unit complies with European standard EN60950.
18. Make sure the repeater settings are according to the intended use (see also product information of
manufacturer) and regulatory requirements are met.
19. Although the repeater is internally protected against overvoltage, it is strongly recommended to earth
the antenna cables close to the repeater’s antenna connectors for protection against atmospheric
discharge.