User's Manual
Table Of Contents
- 1.1. USED ABBREVIATIONS
- 1.2. HEALTH AND SAFETY WARNINGS
- 1.3. ABOUT COMMSCOPE SOLUTIONS
- 1.4. INTERNATIONAL CONTACT ADDRESSES FOR CUSTOMER SUPPORT
- 2. INTRODUCTION
- 3. 3. COMMISSIONING
- 4. ALARMS
- 5. MAINTENANCE
- 6. APPENDIX
- 7. INDEX
25 of 46
3.2.4. Connection of the Antenna Cables
The remote unit has N-type antenna connectors. For its location please refer to
chapter 3.2.2 Connections. For mounting the cable connectors, it is recommended to
refer to the corresponding documentation of the connector manufacturer. The
bending radius of the antenna cables must remain within the given specifications.
For the selection of cable and antenna it should be considered that, on the one hand,
a cable with higher loss is less expensive but, on the other hand, it impairs
performance.
It is sufficient to tighten the N-type antenna connectors hand-tight. The use of
a tool (like pliers) may cause damage to the connector and, therefore, lead to
a malfunctioning of the remote unit.