User's Manual

4. Commissioning

Page 32

Manual ION-M17EP_19P MF0150ACA.docx Manual for ION-

17EP

/19P



Note: Only high-quality connectors must be used for this type of plug.

Qualified brands are Diamond or Huber & Suhner.

For plug assembly, observe the following instruction:

1. Pass one or two contacts through the

backshell and the clamp ring.

2. Place the contact(s) on the lower insulation body by pushing the groove of the

contact into the cavity. If there is only one contact, cavity A must be used. *

3. Then, mount the upper insulation body on the lower insulation body. **

4. Bring the insulator into the plug. The narrow groove of the insulator must be fitted

into the stamp of the plug.

* To release the contact for disassembling, push the inner snap to the side and pull the contact out.

** To release upper and lower insulation bodies for disassembling, use a small screwdriver and

carefully open the snap-connections at the left and the right side of the insulator without damaging

them.

5. Fasten the insulator by screwing the

backshell tight onto it. Use a spanner

with opening 32 to screw the backshell

tight (no gap).

6. Place the appropriate seal parts (with

one groove for one contact or two

grooves for two contacts) over the

cable(s) and push them into the

backshell.

Seals with

one groove

No gap

Upper insulation body

Cavity A

Cavity B