Installation Instruction

ManualsBrandsAndrew Wireless System ManualsElectronicsION-M Remote Unit for cellular systems

Table Of Contents

The Remote Unit, Extension Unit or Master Unit has to be

mounted by proffessionel / special trained installer.

1.1. MECHANICAL INSTALLATION

1.1.1. General

Read the health and safety warnings in chapter 1.3 Health and Safety Warnings.

1. Do not install the unit in a way or at a place where the specifications outlined in the

Environmental and Safety Specifications leaflet of the manufacturer are not met.

2. It is strongly recommended to install the unit vertically. If a different installation of the remote

unit is required, please contact customer service for further information.

3. It is recommended only to use the mounting hardware delivered by the manufacturer. If

different mounting hardware is used, the specifications for stationary use of the remote unit

must not be exceeded.

 Note: Exceeding the specified load limits may cause the loss of warranty!

4. The unit is considerably heavy. Make sure that a suitable mounting surface is used. Ensure

there is adequate manpower to handle the weight of the system.

5. Due to power dissipation, the remote unit may reach a very high temperature. Ensure

sufficient airflow for ventilation. Above and below the unit a minimum distance of 300 mm to

ceiling, floor, etc. has to be kept. Also observe the instructions in the individual mounting

procedures.

6. For outdoor installations, the pre-mounted front cover must be installed.

7. For indoor installations where the ambient temperature can reach above 40°C, the cover has

to be removed.

8. When connecting and mounting the cables (RF, optical, mains, ...) ensure no water can

penetrate into the unit through these cables.

If any different or additional mounting material is used, ensure that the mounting remains as safe as the

mounting designed by the manufacturer. Ensure that the static and dynamic strengths are adequate for

the environmental conditions of the site. The mounting itself must not vibrate, swing or move in any

way that might cause damage to the remote unit.

Summary of content (4 pages)

PAGE 1
Installation Instruction The Remote Unit, Extension Unit or Master Unit has to be mounted by proffessionel / special trained installer. 1.1. MECHANICAL INSTALLATION 1.1.1. General Read the health and safety warnings in chapter 1.3 Health and Safety Warnings. 1. Do not install the unit in a way or at a place where the specifications outlined in the Environmental and Safety Specifications leaflet of the manufacturer are not met. 2. It is strongly recommended to install the unit vertically.
PAGE 2
1.2. ELECTRICAL INSTALLATION 1.2.1. General Read the health and safety warnings in chapter 1.3 Health and Safety Warnings. 1. This unit contains dangerous voltages. Loss of life, severe personal injury or property damage can be the result if the instructions contained in this manual are not followed. 2. It is compulsory to ground the unit before connecting power supply. A grounding bolt is provided on the cabinet to connect the ground-bonding cable. 3.
PAGE 3
1.3. HEALTH AND SAFETY WARNINGS 1. Only suitably qualified personnel is allowed to work on this unit and only after becoming familiar with all safety notices, installation, operation and maintenance procedures contained in this manual. 2. Read and obey all the warning labels attached to the unit. Make sure that the warning labels are kept in a legible condition and replace any missing or damaged labels. 3.
PAGE 4
11. Due to power dissipation, the repeater may reach a very high temperature. Do not operate this equipment on or close to flammable materials. 12. Before opening the unit, disconnect power supply. 13. ESD precautions must be observed! Before commencing maintenance work, use the available grounding system to connect ESD protection measures. 14. This unit complies with European standard EN60950. 15.