User's Manual

User’s Manual for Remote Unit
ION™-M9/18P/21P EP
Page 4 M0143AWA_uc.doc
6. MAINTENANCE 42
6.1. GENERAL 42
6.2. REPLACING THE FAN UNIT 43
6.3. CLEANING THE HEAT SINK 45
7. APPENDIX 46
7.1. ILLUSTRATIONS 46
7.2. SPECIFICATIONS 47
7.2.1. Electrical Specifications 47
7.2.2. Environmental and Safety Specifications 48
7.2.3. Mechanical Specifications 48
7.3. SPARE PARTS 49
8. INDEX 50
FIGURES AND TABLES
figure 3-1 Configuration of an ION-M17P/17P/17P remote unit................................ 14
figure 3-2 Remote unit, front view, fully RF equipped............................................... 15
figure 3-3 Remote unit, backside, fully RF equipped ................................................ 15
figure 4-1 Wall mounting, (metric dimensions).......................................................... 20
figure 4-2 Pole-mounting kit...................................................................................... 21
figure 4-3 Pole mounting (metric dimensions) .......................................................... 22
figure 4-4 Mounting procedure for fan protection, (metric dimensions)..................... 23
figure 4-5 Connector flange of ION-M17P/17P/17P.................................................. 25
figure 4-6 RS232 connector...................................................................................... 26
figure 4-7 Grounding bolt with loosened hex nut ...................................................... 26
figure 4-8 Grounding bolt, schematic view................................................................ 26
figure 4-9 AC mains plug .......................................................................................... 28
figure 4-10 Protective-plug assembly ....................................................................... 30
figure 4-11 Tube-kit installation................................................................................. 33
figure 5-1 Flange connector, 5 poles ........................................................................ 40
figure 5-2 Flange connector, 7 poles ........................................................................ 40
figure 5-3 Alarm inputs and outputs, standard.......................................................... 41
figure 7-1 Installation drawing................................................................................... 46
table 1-1 List of international contact addresses....................................................... 10
table 4-1 Specified torques....................................................................................... 19
table 4-2 RS232 connector, pin assignment............................................................. 26
table 5-1 Status LED alarms..................................................................................... 39