Installation Guide
CommScope ERA
®
Medium Power Carrier Access Point Installation Guide M0201AJG_uc
Page 48 © Decemeber 2020 CommScope, Inc.
Installing CAP Ms
17 On lower right of the CAP M-2, reinstall the M6x12 screw and its washers that you removed in Step 13 on
page 46.
a Slide first the M6 split-lock washer and then the M6 plain washer over the M6x12 screw.
b Insert the M6x12 screw through the screw hole shown below, and screw it back into the CAP M
chassis; torque to 11 N-m.
18 Repeat Step 11 on the left side of CAP M-2.
19 Do one of the following:
• If this installation requires a Hybrid Fiber Splice Box, go to "Attach a Hybrid Fiber Splice Box to the
CAP M” on page 52.
• If this installation does not require a Hybrid Fiber Splice Box, go to "Grounding the CAP M” on
page 56.
M6x12 screw and
washer set in hole
furthest from the
mounng surface