Installation Guide

M0201AJG_uc CommScope ERA

Medium Power Carrier Access Point Installation Guide

Installing CAP Ms

14 Use both handles on the CAP M-2 chassis to lift it above the Mounting Bracket with the back of its chassis

facing the back of CAP M-1, and then lower it into place.

• The M6 pins that you loosened in Step 13 on page 46 must align with the Mounting Bracket slots, as

shown below.

• The washer for each M6 pin should be next to the CAP M-2 chassis (inside the bracket).

15 On the right side of the CAP M-2, torque the M6 pin to 11 N-m.

16 Repeat Step 15 on the left side of the CAP M.

CAP M-2

(back of the CAP M-2 chassis

faces the back of CAP M-1)

M6 Pin with its

washer on the inside

of the bracket,

against the

CAP-M2 chasssis