Installation Guide
M0201AJG_uc CommScope ERA
®
Medium Power Carrier Access Point Installation Guide
© Decemeber 2020 CommScope, Inc. Page 45
Installing CAP Ms
11 On lower right of the CAP M-1, reinstall the M6x12 screw and its washers that you removed in Step 7 on
page 43.
a Slide first the M6 split-lock washer and then the M6 plain washer over the M6x12 screw.
b Insert the M6x12 screw through the screw hole shown below, and screw it back into the CAP M-1
chassis; torque to 11 N-m.
12 Repeat Step 11 on the left side of the CAP M-1.
M6x12 screw and
washer set in hole
closest to the
mounng surface