Installation Guide

CommScope ERA
®
Medium Power Carrier Access Point Installation Guide M0201AJG_uc
Page 44 © Decemeber 2020 CommScope, Inc.
Installing CAP Ms
8 Use both handles on the CAP M-1 chassis to lift it above the Mounting Bracket, and with the front of the
chassis facing the mounting surface, lower it into place.
• The M6 pins that you loosened in Step 7 on page 43 must align with the Mounting Bracket slots, as
shown below.
• The washer for each M6 pin should be next to the CAP M-1 chassis (inside the bracket).
9 On the right side of the CAP M-1, torque the M6 pin to 11 N-m.
10 Repeat Step 9 on the left side of the CAP M.
M6 Pin with its
washer on the inside
of the bracket,
against the
CAP-M1 chasssis
CAP M-1
(front of the CAP M-1 chassis
faces the mounng surface)