Installation Guide

M0201AJG_uc CommScope ERA
®
Medium Power Carrier Access Point Installation Guide
© Decemeber 2020 CommScope, Inc. Page 79
Replacing the Power Supply Unit (PSU)
16 Tighten the eight Torx T-10 screws. The Torque value is 0.82Nm (7 inch pounds).
17 Remount the CAP M. See “Mount the CAP M” on page 33.
18 Reconnect the cables to the CAP M. See “Connect the CAP M Cables” on page 57.
19 Switch on the Mains power and check the CAP M for proper operation.
The green LED starts flashing slowly as CAP M initializes and then turns steady when initialization is
complete.