Manualshelf

Installation Guide

ManualsBrandsAndrew Wireless System ManualsComputers & AccessoriesERA Repeater for cellular systems
31323334353637383940
CommScope ERA
®
Medium Power Carrier Access Point Installation Guide M0201AJG_uc
Page 74 © Decemeber 2020 CommScope, Inc.
Replacing the Power Supply Unit (PSU)
6 Loosen the eight Torx T-10 screws on the PSU. The weight of the power supply must be supported as you
loosen the screws to prevent damage to the supply.
7 Remove the PSU from the housing, being careful not to damage the wires. Do not attempt to support the
weight of the supply with the attached input and output cables. Due to the short length of the cables, once
the top of the PSU is clear of the housing, angle it downward to remove it.
8 Place the PSU on the bench.