Installation Guide

M0201AJG_uc CommScope ERA

Medium Power Carrier Access Point Installation Guide

Replacing the Power Supply Unit (PSU)

CAUTION! Make sure the product label is upside down, the +30 VDC label is on the left and the VAC input is on

the right as shown in the picture below. Failure to follow this orientation may cause damage to the

PSU.

13 Reconnect the input and output connectors and tighten the associated terminal screws.

CAUTION! The connector pins are to the side of the screws farthest from the CAP M housing for both

connectors. These must be reassembled in the same location. Failure to follow this instruction may

result in damaged connectors.

14 Place the plastic guard over both connectors.