Installation Guide

CommScope ERA
®
Medium Power Carrier Access Point Installation Guide M0201AJG_uc
Page 42 © Decemeber 2020 CommScope, Inc.
Installing CAP Ms
3 Refer to "Determine the Mounting Site” on page 24 to determine the mounting location, which must be
able to support the weight and dimensions of the CAP M.
4 Refer to "Mounting Orientation” on page 34 to determine the mounting orientation of the CAP M.
5 Refer to and observe all cautions listed in "General Mounting Cautions” on page 33.
6 Secure the Mounting Bracket to the wall (or another suitable vertical surface) as shown below.
a Install the mounting bracket using 4 M6 screw anchors (not included) or suitable lag bolts according
to the drilling layout.
b Confirm that the bracket is securely fastened to the wall.
Installer must verify that the mounting surface will safely support the combined load of the electronic
equipment and all attached hardware and components.
The M6 screw anchors do not ship with the CAP M as the anchor type is dependent on the on-site
conditions (wall structure and materials). Use screw anchors that are rated for the mounting surface.
Dual Mounng Bracket
1
2
3
4
1
through
4
are the four screw anchors