Installation Guide

CommScope ERA
®
Medium Power Carrier Access Point Installation Guide M0201AJG_uc
Page 58 © Decemeber 2020 CommScope, Inc.
Installing CAP Ms
• If connecting an external Ethernet device such as WiFi or IP camera, an Ethernet OCTIS Kit (PN 7760652)
and appropriate CAT cable for the device.
Connect the CAP M to an RF Antenna
The following sections guide you through connecting the CAP M; complete these procedures in the order in
which they are presented.
• "Clean the RF Cable Connectors” on page 58
• "Connect the Antenna Cable(s)” on page 61.
Clean the RF Cable Connectors
This section tells you how to clean RF cable connectors. The graphics in this section illustrate the cleaning
procedure and do not show the CAP M.
Do the following to clean the RF cable connectors.
780 134 4 SFP+, 10GBase CWDM-530 40km
780 136 0 SFP+, 10GBase CWDM-550 40km
780 136 3 SFP+, 10GBase CWDM-570 40km
780 136 5 SFP+, 10GBase CWDM-590 40km
780 136 7 SFP+, 10GBase CWDM-610 40km
783 220 4 SFP+, 10G BIDI TX1270/RX1330 40km
783 220 6 SFP+, 10G BIDI TX1330/RX1270 40km
This procedure requires the use of compressed air. Wear protective clothing—especially protective
glasses—to protect against injury from flying particles.
This procedure requires the use of flammable material. There is a risk of fire. Keep away from sources of
ignition.
This procedure requires the use of eye irritant product. There is a risk of eye irritation. Avoid contact with
eyes and skin. Wear protective clothing—especially protective glasses.
1 Gather the following cleaning tools:
• Isopropyl alcohol
• Compressed air
• Lint-free wipe
• Cotton buds.
Table 12. Supported SFP+ Modules
CommScope PN Description Maximum Range