Installation Guide

CommScope ERA
®
Medium Power Carrier Access Point Installation Guide M0201AJG_uc
Page 56 © Decemeber 2020 CommScope, Inc.
Installing CAP Ms
Grounding the CAP M
1 Connect an earth-bonding cable to the grounding bolt connections on the outside of the CAP M chassis, as
shown below.
2 Loosen the M6 hex nut(s), and then connect the
earth-bonding cable between the two washers as
shown to the right.
3 Secure the earth-bonding cable by tightening the
M6hex nut(s) that you loosened in the preceding step.
4 Connect the other end of the earth-bonding cable to a
suitable permanent ground per local electrical code
practices.
5 Follow the steps in "Connect the CAP M Cables” on
page 57.
The CAP M must be grounded.
Do not use the grounding bolts to connect an external device.
Grounding bolts
Plain washers
M6
hex
nut
Locking
ring
M6
hex
nut
Earth-Bounding
cable