Installation Guide

M0201AJG_uc CommScope ERA

Medium Power Carrier Access Point Installation Guide

Installing CAP Ms

3 Remove the six neck screws (shown below) from the front cover of the Splice Box.

4 Open the Splice Box.

5 Attach an M4 x 25 pan-head screw to the upper hole, and a

second M4 x 25 pan-head to the hole on the lower, left-hand side

(shown at right) of the Splice Box.

6 Close the Splice Box.

7 Replace the six neck screws that you removed from the front

cover of the Splice Box in Step 3 on page 55.

8 Go to "Grounding the CAP M” on page 56.