Installation Guide

M0201AJG_uc CommScope ERA

Medium Power Carrier Access Point Installation Guide

Installing CAP Ms

2 Remove the six neck screws (shown below) from the front cover of the Splice Box.

3 Open the Splice Box.

4 Attach an M4 x 25 pan-head screw to the upper hole, and a second M4 x 25 pan-head to the hole on the

lower, right-hand side of the Splice Box.

5 Close the Splice Box.

6 Replace the six neck screws that you removed from the front cover of the Splice Box in Step 2 on page 53.

7 Go to "Grounding the CAP M” on page 56.