Installation Guide

CommScope ERA
®
Medium Power Carrier Access Point Installation Guide M0201AJG_uc
Page 40 © Decemeber 2020 CommScope, Inc.
Installing CAP Ms
11 On lower right of the CAP M, reinstall the M6x12 screw and its washers that you removed in Step 7 on
page 37.
a Slide first the M6 plain washer and then the M6 split-lock washer over the M6x12 screw.
b Insert the M6x12 screw through the screw hole shown below, and screw it back into the CAP M
chassis; torque to 11 N-m.
12 Repeat Step 11 on the left side of the CAP M.
13 Do one of the following:
• If this installation requires a Hybrid Fiber Splice Box, go to "Attach a Hybrid Fiber Splice Box to the
CAP M” on page 52.
• If this installation does not a Hybrid Fiber Splice Box, go to "Grounding the CAP M” on page 56.
M6x12 screw
and
washer set