Installation Guide

M0201AJG_uc CommScope ERA

Medium Power Carrier Access Point Installation Guide

Installing CAP Ms

10 If a second splice holder is needed, it can be assembled using the M4

insulating washer and two M4 plain washers, as shown to the right. The

required screw is a PTK30 x 12.

11 Remove the sealing nut and rubber of the cable gland and insert the

optical cables.

12 Place each cable into one of the grooves of the seal insert.

13 Press the seal insert into the clamp ring opening.

14 Fix the optical cables inside the box using one cable tie and tight the

sealing nut.

15 It is possible to separate the optical cables and use two different cable

glands. Remove the sealing nut and rubber on each cable gland.

16 Close all unused grooves with the plastic cylinders, no matter if one or

two cable glands are used.