Installation Guide

CommScope ERA
®
Medium Power Carrier Access Point Installation Guide M0201AJG_uc
Page 14 © Decemeber 2020 CommScope, Inc.
CAP M Overview
2 Remove the primary tab of the RJ-45 connector using wire cutters.
Figure 12. RJ-45 Primary Tab Removal
3 Insert the RJ-45 connector into the OCTIS connector shell as described in the“OCTIS RJ45 Reverse Lever
Assembly Instructions” on page 12 or in the printout included with the connector.
4 Use the OCTIS dust cover to verify that the RJ-45 connector extends the correct distance beyond the shell
using the indicator line on the dust cover.
Figure 13. RJ-45 Dust Cover Alignment
5 Complete the assembly of the OCTIS connector by following the OCTIS User Instructions printout
included with the connector. The final assembly is shown in Figure 14 on page 14.
Figure 14. GigaSPEED X10D RJ-45 Correctly Installed in OCTIS Connector