Installation Guide

Table Of Contents

M0203AHA_uc CommScope ERA

CAP M2 with Fiber Interface

Mount the Fiber CAP M2

Prepare for CAP M2 Hybrid Fiber Splice Box Kit Installation

1 Follow the steps in "Unpack and Inspect the CAP M2 and Optional Accessories” on page 16.

2 Refer to "Determine the CAP M2 Installation Site” on page 14 to determine the mounting location, which

must be able to support the weight and dimensions of the CAP M2.

3 Refer to "Mounting Orientation for Wall Mounts” on page 18 to determine the mounting orientation of the

CAP M2.

Assembling and Wiring the Hybrid Fiber Splice Box

The following subsections describe how to assemble the Hybrid Fiber Splice Box and then how to wire it to

provide power to the CAP M2:

• "Assembling and Wiring the Hybrid Fiber Splice Box” on page 23 tells you how to place the wires into the

Hybrid Fiber Splice Box.

Wire the Hybrid Fiber Splice Box

Do the following to assemble and wire the Hybrid Fiber Splice Box.

1 Open the Hybrid Fiber Splice Box and remove the installation kit that is

inside.

2 Using the parts from the Hybrid Fiber Splice Box, insert the Splice

Holder and fasten it using a PTK 30x6 screw and one M4 washer.