Installation Guide

Table Of Contents

M0203AHA_uc CommScope ERA

CAP M2 with Fiber Interface

Mount the Fiber CAP M2

Mounting CAP M2 with a Wall Mounting Kit

The following sections provide the installation methodology and steps required to mount a CAP M2 to a wall.

When wall mounting a CAP M2, the recommendations should be observed.

1 Use "Plan and Prepare for a Fiber CAP M2 Installation” on page 13 to identify the installation site and

installation requirements, and to prepare for the installation.

2 Refer to and observe all cautions listed in "General Mounting Cautions” on page 17.

3 Determine the mounting orientation of the Fiber CAP M2. Refer to "Mounting Orientation for Wall Mounts”

on page 18 to determine the mounting orientation of the CAP M2.

4 Hold the wall mounting bracket on the wall where the CAP M2 will be mounted and mark the location of

the holes on the wall.

The CAP M2 must be installed with the antenna ports point downward. See "Mounting Orientation for

Wall Mounts” on page 18.

Table 11. Wall Mount Kit (784842) components

Part Number Region Quantity Component

7851781-00 EMEA 1 Wall Mounting Bracket, single

NOTE: Kit included with CAP M2

7851753 NAR 2 NAR Wall mounting brackets CAP M2, single

NOTE: Kit must be order from CommScope