Installation Guide

Table Of Contents

M0203AHA_uc CommScope ERA

CAP M2 with Fiber Interface

Fiber CAP M2 Overview

OCTIS™ Universal Lever Assembly Kits

Scan the QR code to the right to watch the OCTIS SFP+ connector assembly video.

All CAP M2s include two OCTIS Universal Connector Kits (CommScope PN 7847069) for the interface to the

Classic CAN or TEN that plugs into Port 1 and Port 2 on the CAP M2. CommScope provides the two OCTIS Kits

for each CAP M2.

OCTIS Universal Lever Assembly Instructions

The following instructions are for the OCTIS Universal Lever kit (CommScope PN: 7847069). For additional

information, please contact Radiall.

A784685 7 BIDI 40km Kit

1 x Attenuator, LC/UPC, 7dB A7843668

1 x 10G BIDI SFP+ TX1270/RX1330 40km

A7832204

1 x 10G BIDI SFP+ TX1330/RX1270 40km

A7832206

40km

OCTIS™ is a trademark of Radiall. The following connector drawings and instructions were provided by

Radiall.

Table 8. CAP M2 OCTIS Kits

Kit Name CommScope PN Description

OCTIS Universal

Connector Kit

7847069 This is the connector that you use to seal the fiber cable port.

The OCTIS Universal Kit is provided with the CAP M2.

Fiber/Cable

Protective Kit

7823597 Use to protect fibers or cables; is 2m (78.7”) long.

NOTE: An Optical OCTIS Kit is required and must be ordered

separately.

Octis™ is a trademark of Radiall. The following connector drawings and instructions were provided by

Radiall.

Table 7. Supported SFP+ Modules (Continued)

CommScope PN Description Maximum Range

Protective Kit

OCTIS Kit