Installation Guide

Table Of Contents

M0203A9B_uc CommScope ERA

CAP L2 with Fiber Interface

DOCUMENT OVERVIEW

CAP L2 variants are available with either a copper entry module or fiber entry module. The "C" in the variant

name (after the band numbers) indicates a copper entry module and an "F" indicates a fiber entry module.

The copper entry module supports up to two 10GBase-T (CAT6A) interfaces and the fiber entry module

supports up to two 10G/25G SFP+ optical fiber interfaces. This guide provides a product overview and

installation instructions for the fiber CAP L2 APs.

Table 1 lists the supported CAP L2 variants.

Document Revision History

This is the second release of the CommScope ERA™ CAP L2 Second Generation Fiber Low Power Carrier Access

Point Installation Guide. This release:

• adds the CAP L2 35LT/35HT and CAP L2 C-band models to Table 1 on page 1 and Table 3 on page 8

• adds representative information to Step 4 on page 5

• adds Radio Module information to Table 3 on page 8

• adds "Required Antenna Distances” on page 8

• adds 4 antenna information in Figure 2 on page 10 and Figure 6 on page 10

• adds Fiber/Cable Protective Kit row to Table 9 on page 13

Document Cautions and Notes

This document may contain any of the following notes, cautions, and warning icons.

Table 1. Supported CAP L2 Fiber Models

Part Number Model Name

784 5 3 90 -1 0 01 CAP L2 18/ 21/ 23 T/ 26 F-D C

784 5 3 90 -1 0 03 CAP L2 3 5LT/ 3 5HT F -D C

784 5 3 90 -1 0 07 CAP L2 17E /1 9/ 23/ 25T F-DC

784 5 3 90 -1 0 08 CAP L2 6/7 E/ 80-8 5 F - DC

784 5 3 90 -1 0 09 CAP L2 9/1 8/2 1/ 26 F -DC

784 5 3 90 -1 0 13 CAP L2 7-8 /9 /18 /21 F- DC

784 5 3 90 -1 0 18 CAP L2 C -B and F -DC

F in n ame ( aft er th e b a nds ) st an ds f o r Fibe r

For information on how to find the minimum software requirements for ERA hardware, refer to

"Hardware to Software Mapping Information” on page 47.

The icon to the left is used to indicate a caution or warning. Cautions and warnings indicate operations or

steps that could cause personal injury, induce a safety problem in a managed device, destroy or corrupt

information, or interrupt or stop services.

The icon to the left indicates a caution or warning that pertains to laser equipment.