Installation Guide
Table Of Contents
- Table of Contents
- Document Overview
- Fiber CAP L2 Overview
- Plan and Prepare for a Fiber CAP L2 Installation
- Mount the Fiber CAP L2
- General Mounting Cautions
- Mounting CAP L2 with a Wall Mounting Kit
- Mounting a CAP L2 with an AC/DC Power Supply Kit
- Wiring the AC/DC Power Supply Kit
- Mounting a CAP L2 with a Hybrid Fiber Splice Box Kit (optional)
- Connect the Cables to the Fiber CAP L2
- Powering on a Fiber CAP L2
- Contacting CommScope
CommScope ERA
®
CAP L2 with Fiber Interface M0203A9B_uc
Page 44 © September 2022 CommScope, Inc.
Connect the Cables to the Fiber CAP L2
5 Connect the LC connector to the SFP+ module inside the CAP L2.
6 Replace the cover on the CAP L2.
Connect the Fiber CAP L2 to a Classic CAN or TEN
1 Connect the CAP L2 Optical Port 1 as appropriate for this installation.
a Remove the dust cap from the CAP L2 Optical Port 1 connector and the connectors on the SMF or
MMF.
b Follow the local cleaning technique to clean Optical Port 1.
c Clean the connectors on the SMF or MMF following the fiber supplier’s recommendations.
d Install the SFP+ connector and Optical OCTIS Kit on the end of the SMF or MMF that will connect to
the CAP L2.