Installation Guide
Table Of Contents
- Table of Contents
- Document Overview
- Fiber CAP L2 Overview
- Plan and Prepare for a Fiber CAP L2 Installation
- Mount the Fiber CAP L2
- General Mounting Cautions
- Mounting CAP L2 with a Wall Mounting Kit
- Mounting a CAP L2 with an AC/DC Power Supply Kit
- Wiring the AC/DC Power Supply Kit
- Mounting a CAP L2 with a Hybrid Fiber Splice Box Kit (optional)
- Connect the Cables to the Fiber CAP L2
- Powering on a Fiber CAP L2
- Contacting CommScope
CommScope ERA
®
CAP L2 with Fiber Interface M0203A9B_uc
Page 40 © September 2022 CommScope, Inc.
Connect the Cables to the Fiber CAP L2
Connect the Passive RF Antenna
Do the following to connect a Fiber CAP L2 to a passive RF antenna.
1 Connect the CAP L2 ANT 1 or ANT 2 connector to a passive RF antenna.
a Locate the 50
coaxial cables obtained for this installation; see "Obtain the Required Materials” on
page 18.
b Install the passive antennas per the manufacturer’s installation instructions.
c Remove the plastic-protective cap from the 4.3-10 connectors.
d Remove the IP67/EMI blank plug from the ANT 1/2 connector.
e Connect the passive antenna to the ANT 1 or ANT 2 connector using coaxial cable with the least
amount of loss possible.
9 Use compressed air to remove metal chips and small particles
from the mating and inner surfaces of the connector.
10 Use a lint-free wipe drenched with isopropyl alcohol to clean the
winding area.
11 Use a cotton bud drenched with isopropyl alcohol to clean the
inside mating surface of the inner ring.
12 Use a cotton bud drenched with isopropyl alcohol to clean the
outside surface of the center pin.