Installation Guide
Table Of Contents
- Table of Contents
- Document Overview
- Fiber CAP L2 Overview
- Plan and Prepare for a Fiber CAP L2 Installation
- Mount the Fiber CAP L2
- General Mounting Cautions
- Mounting CAP L2 with a Wall Mounting Kit
- Mounting a CAP L2 with an AC/DC Power Supply Kit
- Wiring the AC/DC Power Supply Kit
- Mounting a CAP L2 with a Hybrid Fiber Splice Box Kit (optional)
- Connect the Cables to the Fiber CAP L2
- Powering on a Fiber CAP L2
- Contacting CommScope
M0203A9B_uc CommScope ERA
®
CAP L2 with Fiber Interface
© September 2022 CommScope, Inc. Page 35
Mount the Fiber CAP L2
2 After you have wired the Hybrid Fiber Splice box, complete the steps in "Wall Mount a CAP L2 Using a
CAP L2 Hybrid Fiber Splice Box Kit (optional)” on page 35.
Wall Mount a CAP L2 Using a CAP L2 Hybrid Fiber Splice Box Kit (optional)
1 Remove the Hybrid Fiber Box cover.
2 Attach the Hybrid Fiber Splice Box to the Wall Bracket with the three captive screws already installed in
the Splice Box.
3 Replace the cover.
4 Attach the assembled Wall Mounting Bracket and Hybrid Splice Box to the selected mounting location.
5 If required, install an SFP+ module and follow the instructions in "Installing SFP+ Modules in the CAP L2
(optional)” on page 42.
6 Follow procedure in "Mounting CAP L2 with a Wall Mounting Kit” on page 21.
The steps in this section pertain only to those installations that require the use of the optional Hybrid
Fiber Splice Box to provide fiber and power to the CAP L2.