Installation Guide
Table Of Contents
- Table of Contents
- Document Overview
- Fiber CAP L2 Overview
- Plan and Prepare for a Fiber CAP L2 Installation
- Mount the Fiber CAP L2
- General Mounting Cautions
- Mounting CAP L2 with a Wall Mounting Kit
- Mounting a CAP L2 with an AC/DC Power Supply Kit
- Wiring the AC/DC Power Supply Kit
- Mounting a CAP L2 with a Hybrid Fiber Splice Box Kit (optional)
- Connect the Cables to the Fiber CAP L2
- Powering on a Fiber CAP L2
- Contacting CommScope
M0203A9B_uc CommScope ERA
®
CAP L2 with Fiber Interface
© September 2022 CommScope, Inc. Page 29
Mount the Fiber CAP L2
Assembling and Wiring the Hybrid Fiber Splice Box
The following subsections describe how to assemble the Hybrid Fiber Splice Box and then how to wire it to
provide power to the CAP L2:
• "Assembling and Wiring the Hybrid Fiber Splice Box” on page 29 tells you how to place the wires into the
Hybrid Fiber Splice Box.
• You then need to follow one of the following procedures that meets the powering requirements of this
installation.
– "Wire a Hybrid Fiber Splice Box for 4-Wire Power with Limited Power Source” on page 33
– "Wire a Hybrid Fiber Splice Box for 2-Wire Power without Limited Power Source” on page 34
Wire the Hybrid Fiber Splice Box
Do the following to assemble and wire the Hybrid Fiber Splice Box.
1 Open the Hybrid Fiber Splice Box and remove the installation kit that is
inside.
2 Using the parts from the Hybrid Fiber Splice Box, insert the Splice
Holder and fasten it using a PTK 30x6 screw and one M4 washer.
3 From the CAP L2 Hybrid Fiber Splice Box Kit, insert Fiber Patch Cord in
one of the cable glands indicated in the graphic to the right.