Installation Guide
Table Of Contents
- Table of Contents
- Document Overview
- Fiber CAP L2 Overview
- Plan and Prepare for a Fiber CAP L2 Installation
- Mount the Fiber CAP L2
- General Mounting Cautions
- Mounting CAP L2 with a Wall Mounting Kit
- Mounting a CAP L2 with an AC/DC Power Supply Kit
- Wiring the AC/DC Power Supply Kit
- Mounting a CAP L2 with a Hybrid Fiber Splice Box Kit (optional)
- Connect the Cables to the Fiber CAP L2
- Powering on a Fiber CAP L2
- Contacting CommScope
CommScope ERA
®
CAP L2 with Fiber Interface M0203A9B_uc
Page 22 © September 2022 CommScope, Inc.
Mount the Fiber CAP L2
4 Use the wall bracket as a template to mark the holes at the location where you will mount the UAP 2.
5 Secure the wall mount bracket to the wall, using four anchor screws.
6 Confirm that the Wall Mount Bracket is securely fastened to the wall.
The anchor screws do not ship with the CAP L2 as the anchor type is dependent on the on-site
conditions (wall structure and materials). Use screw anchors that are rated for the mounting surface.
The hole for the screws in the bracket is 7.5 mm in diameter and will accommodate screws
between 5.8 mm and 7.5 mm.