Installation Guide
Table Of Contents
- Table of Contents
- Document Overview
- Fiber CAP L2 Overview
- Plan and Prepare for a Fiber CAP L2 Installation
- Mount the Fiber CAP L2
- General Mounting Cautions
- Mounting CAP L2 with a Wall Mounting Kit
- Mounting a CAP L2 with an AC/DC Power Supply Kit
- Wiring the AC/DC Power Supply Kit
- Mounting a CAP L2 with a Hybrid Fiber Splice Box Kit (optional)
- Connect the Cables to the Fiber CAP L2
- Powering on a Fiber CAP L2
- Contacting CommScope
M0203A9B_uc CommScope ERA
®
CAP L2 with Fiber Interface
© September 2022 CommScope, Inc. Page 13
Fiber CAP L2 Overview
OCTIS™ Universal Lever Assembly Kits
Scan the QR code to the right to watch the OCTIS SFP+ connector assembly video.
All CAP L2s include two OCTIS Universal Connector Kits (CommScope PN 7847069) for the interface to the
Classic CAN or TEN that plugs into Port 1 and Port 2 on the CAP L2. CommScope provides the two OCTIS Kits
for each CAP L2.
Figure 3 and Figure 4 show the LC Duplex connector. The single fiber assembly instructions are the same.
OCTIS Universal Lever Assembly Instructions
The following instructions are for the OCTIS Universal Lever kit (CommScope PN: 7847069). For additional
information, please contact Radiall.
OCTIS™ is a trademark of Radiall. The following connector drawings and instructions were provided by
Radiall.
Table 9. CAP L2 OCTIS Kits
Kit Name CommScope PN Description
OCTIS Universal
Connector Kit
7847069 This is the connector that you use to seal the fiber cable port.
The OCTIS Universal Kit is provided with the CAP L2.
Fiber/Cable
Protective Kit
7823597 Use to protect fibers or cables; is 2m (78.7”) long.
NOTE: An Optical or Ethernet OCTIS Kit is required and
must be ordered separately.
Octis™ is a trademark of Radiall. The following connector drawings and instructions were provided by
Radiall.
OCTIS Kit Protective Kit