Installation Guide

CommScope ERA
®
CAP L2 with Fiber Interface M0203A9B_uc
Page 6 © September 2022 CommScope, Inc.
Document Overview
transmitter. Users and installers must be provided with antenna installation instructions and transmitter
operating conditions for satisfying RF exposure compliance.
French:
Cet appareil est conforme avec Sante Canada Code de securite 6. Le programme d'installation de cet
appareil doit s'assurer que les rayonnements RF n'est pas emis au-dela de I'exigence de Sante Canada. Les
informations peuvent etre obtenues:
http://www.hc-sc.gc.ca/ewh-semt/pubs/radiation/radio_guide-lignes_direct-eng.php
Les changements ou modifications non expressement approuves par la partie responsable de la
conformite pourraient annuler l'autorite de l'utilisateur a utiliser cet equipement.
Antenne Déclaration pour ISDE:
Ce dispositif a ete designe pour fonctionner avec les antennes ayant un gain maximal de 9 dBi. Antennes
ayant un gain plus grand que 9 dBi sont interdites pour une utilisation avec cet appareil sans le
consentement des organismes de reglementation d'ISDE. L'impedance d'antenne requise est 50 ohms.
L'antenne (s) utilise pour cet emetteur doit etre installe pour fournir une distance de separation minimale
par rapport a toute personnes et ne doit pas etre co-localisees ou operant en conjonction avec une autre
antenne ou emetteur. Les utilisateurs et les installateurs doivent etre fournis avec des instructions
d'installation de l'antenne et des conditions de fonctionnement de l'emetteur pour satisfaire la
conformite aux expositions RF.
5 Notice: The unit complies with Overvoltage Category II. It also complies with the surge requirement
according to EN 61000-4-5 (fine protection); however, installation of an additional medium (via local
supply connection) and/or coarse protection (external surge protection) is recommended depending on
the individual application in order to avoid damage caused by overcurrent.
For Canada and US, components used to reduce the Overvoltage Category shall comply with the
requirements of IEC 61643-series. As an alternative, components used to reduce the Overvoltage
Category may comply with ANSI/IEEE C62.11, CSA Certification Notice No. 516, CSA C22.2 No. 1, or UL
1449. Suitability of the component for the application shall be determined for the intended installation.
6 Notice: Corresponding local particularities and regulations must be observed. For national deviations,
please refer to the respective documents, which are available from CommScope.
7 Note: For a Class B digital device or peripheral:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Canadian Representative
ISED Company No: 3874A
Company Name: Celltech Labs Inc.
Address: 21-364 Lougheed Road
Kelowna, BC V1X 7R8
Contact Name: Ben Hewson
Telephone No: [phone] x201
Email: [e-mail]