User's Manual Part 3

M0201AA ION
®
-E Series Hardware Installation Guide
© June 2017 CommScope, Inc. Page 113
Installing CAP Ls
4 Ifappropriateforthisinstallation,connecttheOpticalPort2connector.
a RaisetheleverontheEMI/IP67caponOpticalPort2connectorandremovethecap.
b RemovethecapsfromtheconnectorsontheSMorMMfiber.
c FollowthelocalcleaningtechniquetocleanOpticalPort2.
d CleantheconnectorsontheSMForMMFfollowingthefibersupplier’srecommendations.
e ConnectoneendoftheSMForMMFtotheOpticalPort2connectorandtheotherendto[to what
EXACTLY does the other end of the cable connect on the CAN/TEN or junction box
?]
UNRESOLVED: If Opt 2 can connect to a local Hybrid Fiber Junction Box or a cascaded CAP L to provide the
main signal and power interface, when does optical transport occur over Single Mode (SM)
or Multi Mode (MM) fiber? We need to identify what type of cable to use, and does the
customer supply the cable or does it ship with the CAP
L?
5 ConnecttheAuxiliaryconnectorasappropriateforthisinstallation.
a RaisetheleverontheEMI/IP67capontheAuxiliaryconnectorandremovethecap.
UNRESOLVED: AUX port can connect to external Ethernet devices such as WiFi and IP cameras. What type
of cable do you use for each? Cabling is via the appropriate CAT cable for the protocol; this
model supports an 1000 BASE-T and 802.3at Class 3 PoE (minimum) Ethernet connection.
We need to identify what type of cable to use, and does the customer supply the cable or
does it ship with the CAP
L?
UNRESOLVED: Verify that maximum attached cable length is 3 meters (9.8 feet).
UNRESOLVED: To what does the other end of the cable connect to on external Ethernet devices such as WiFi
and IP cameras?
6 ConnecttheVdcPowerconnectorasappropriateforthisinstallation.
a FindtheLocalPowerJumperCableAssemblythatwasshippedwiththemountingkit.
b Connectthefour-pinconnectortotheVdcPowerconnectorontheCAPL.
UNRESOLVED: Spec stated that this model can connect to a local or external power supply, or to a Hybrid
Fiber Junction Box, is the power cable the same for all three options? For each option, to
what does the power cable connect?
TheCAPLispoweredonassoonasyouconnecttheLocalPowerJumperCableAssemblytoapower
source;see
"PoweringaCAPL”onpage82.