User's Manual Part 2

M0201AA ION
®
-E Series Hardware Installation Guide
© June 2017 CommScope, Inc. Page 65
Installing UAPs
4 RemovethefourM5X10mountingscrewslocatedonthebackoftheUAP.
5 PlacetheUAPbracketovertheUAPandinsertandtightenthefourM5X10screwstosecurethebracket
totheUAP.
6 ConnectCat6AcablestoUAPports.
7 IfgroundingisrequiredattachanappropriategroundwiretothegreengroundingscrewoftheUAP.
Grounding is not mandatory. UAPs are classified as low-voltage devices and do not have internal power
supplies. However, CommScope recommends you check local and national electrical codes to determine
if grounding is a requirement for the location in which you are installing the UAP.
UAP
Mounng
Bracket
4 M5x10
Mounng screws