User's Manual Part 2

M0201AA ION
®
-E Series Hardware Installation Guide
© June 2017 CommScope, Inc. Page 103
Installing CAP Ls
m Itispossibletoseparatetheopticalcablesandusetwodifferent
cableglands.Removethesealingnutandrubberoneachcable
gland.
n Closeallunusedgrooveswiththeplasticcylinders
(PN
7157164),nomatterifoneortwocableglandsareused.
o Insertthecopperwiresinthefirstmultipleterminalconnectors.
Seemarkingsontheinternalsupport.Thenfastenthecopper
cablesinsidetheboxusingonecabletie(PN
7582282).
p RemovethesealingnutandinserttheRemoteUnitsupplycable
(PN
7163674)andtightenthesealingnut.
q Connectthesupplycabletotheterminalstripandfixitinsidethe
boxusingonecabletie(PN
7582282).Itispossibletoconnecta
secondsupplycable.
r IncaseofusingremoteunitVdc/100connectthesupplycable
(PN
7669706-00)asshownbesides.Refertomarkingsonthe
internalsupport.