User's Manual Part 2

M0201AA ION
®
-E Series Hardware Installation Guide
© June 2017 CommScope, Inc. Page 89
Installing CAP Ls
INSTALLING CAP LS
Prepare for Installation
Dothefollowingbeforebeginninginstallation.
• Reviewandknowthecautionsin"GeneralInstallationSafetyRequirements”onpage95.
• Reviewthesystemdesignplan.
• Identifytheequipmentinstallationsite.
• Reviewthepowerrequirementstomakesurethesitecansupportthisinstallation.
• Mapoutallcableruns.
• Identifyandobtainalltoolsandmaterialsrequiredtocompletetheinstallation.
Recommended Tools
• ElectrostaticDischarge(ESD)wriststrap
• #2Phillipsscrewdriver
• DrillandbitstomountCAPLtoawallorceiling[not sure what tools are needed]
• Fibercleaningequipment
Recommended Materials
• #18AWG(1.0mm)insulatedstrandedcopperwireforchassisground[I used a standard gauge, not sure if
we recommend this or another gauge
]
• some type of screw to attach mounting brackets to wall/ceiling
This section describes how to install a CAP L; for information on how to install a UAP, UAP-N25, or UAP-X,
go to "Installing UAPs” on page 53.