User's Manual Part 1

M0201AA ION

-E Series Hardware Installation Guide

WCS-2 and WCS-4 Subracks and Modules

Optical Transport Card (OPT)

TheOPTprovidesa10GbfiberconnectionbetweenaCANandaTEN.WhereyouinstallanOPTCardina

WCS-2orWCS-4SubrackisdependentwhetherthesubrackisconfiguredasaCANoraTEN:

• CAN—SlotL1-L8.

• TEN—SlotR1only,andtheSFP+transceivermustbeinstalledintheOPTSFPPort1.

OPT Card SFP Connectors

Ref # Component Device Function

1 1 - 4 10 Gbps SFP port for

Multi-Mode or

Single-Mode fiber

Support for up to four SFP+ transceivers; each SFP port provides

high-speed fiber connections between a CAN and a TEN.

OPT Card SFP Port LEDs

1, 2

Ref # LED LED Color Description

2 1 - 4 • Off • The OPT Card has no power, or the OPT Card is plugged into the wrong

subrack slot (see "WCS Subrack Front Panel Card Slots and GUI

Identification” on page 15).

• Green • Optical link is established with device to which the port is connected.

• Yellow • The OPT Card is powered and initialized, but the link with the

corresponding SFP port is not established.

1 SFP Port LED numbers correspond with the SFP port numbers.

2 When the OPT Card is installed in a TEN, only SFP Port LED 1 is functional.