Installation Guide

CommScope ERA
®
High Power Carrier Access Point Installation Guide M0201AKG_uc
Page 44 © February 2021 CommScope, Inc.
Installing a CAP H
Connect the Optical Fiber
1 Contact your local CommScope sales representative to obtain the following components, as required, for
this installation.
• Per the installation plan, obtain either Single Mode Fiber (SMF) or Multi Mode Fiber (MMF) that is of
sufficient length to reach from the CAP H to a Classic CAN or TEN.
• All CAP Hs ship with the required Optical OCTIS Kit (PN 7770612). If cascading a Secondary CAP H, a
second Optical OCTIS Kit is required. (Cascading of CAP H APs requires V2.7 or higher.)
• Obtain SFP+ Module pairs (one placed in the TEN and paired with another in the Classic CAN) that are
appropriate for this installation. Table 12 identifies the available SFP+ Modules and the maximum
range for each.
Table 12. Supported SFP+ Modules
CommScope PN Description Maximum Range
766 05 1 1 SFP+, 10GBase-SRR, Multi Mode OM3 300m
OM4 400m
768 08 1 3 SFP+, 10GBase-LR, Single Mode 10km
780 32 4 7 SFP+, 10GBase CWDM-270 40km
780 32 4 9 SFP+, 10GBase CWDM-290 40km
780 32 9 1 SFP+, 10GBase CWDM-310 40km
780 32 9 3 SFP+, 10GBase CWDM-330 40km
780 32 9 5 SFP+, 10GBase CWDM-350 40km
780 32 9 8 SFP+, 10GBase CWDM-370 40km
780 39 0 0 SFP+, 10GBase CWDM-390 40km
780 39 0 2 SFP+, 10GBase CWDM-410 40km
780 39 0 4 SFP+, 10GBase CWDM-430 40km
780 39 0 6 SFP+, 10GBase CWDM-450 40km
780 13 3 0 SFP+, 10GBase CWDM-470 40km
780 13 4 0 SFP+, 10GBase CWDM-490 40km
780 13 4 2 SFP+, 10GBase CWDM-510 40km
780 13 4 4 SFP+, 10GBase CWDM-530 40km
780 13 6 0 SFP+, 10GBase CWDM-550 40km
780 13 6 3 SFP+, 10GBase CWDM-570 40km
780 13 6 5 SFP+, 10GBase CWDM-590 40km
780 13 6 7 SFP+, 10GBase CWDM-610 40km
783 22 0 4 SFP+, 10G BIDI TX1270/RX1330 40km
783 22 0 6 SFP+, 10G BIDI TX1330/RX1270 40km