Installation Guide

M0201AKG_uc CommScope ERA
®
High Power Carrier Access Point Installation Guide
© February 2021 CommScope, Inc. Page 15
CAP H Overview
OCTIS™ Kits
All CAP H units include one OCTIS Kit for the primary interface to a Classic CAN or TEN that CAP H plugs into
the CAP H Optical Port 1. You can order an additional OCTIS Kit, which would allow you to cascade two
CAP Hs via Optical Port 2.
OCTIS Kit Instructions
The following instructions are for the OCTIS SFP+ Reverse Lever kit (CommScope PN: 7770612). For more
information, please contact Radiall.
OCTIS SFP+ Reverse Lever Assembly Instructions
Scan the QR code to the right to watch the OCTIS SFP+ connector assembly video.
Table 5. CAP H OCTIS Kits
Kit Name
CommScope
PN
Description
Optical OCTIS Kit
(SFP+)
7770 6 12 Use as follows:
• Optical Port 1—to connect the CAP H to a Classic
CAN or TEN.
• Optical Port 2—to cascade a second CAP H.
• Ships with the following grommets:
– 6mm nominal diameter for use with cables
with OD range from 4.8-5.8
– 7mm nominal diameter for use with cables
with OD range from 5.8-6.8
– 8mm nominal diameter for use with cables
with OD range from 6.8-7.8
Octis™ is a trademark of Radiall. The following connector drawings and instructions were provided by
Radiall.