Installation Guide
Table Of Contents
- Table of Contents
- Document Overview
- ERA System Overview
- CAP H Overview
- Safely Working with a CAP H
- Installing a CAP H
- Using the Status LED to Determine State of the CAP H
- Maintenance
- Contacting CommScope
CommScope ERA
®
High Power Carrier Access Point Installation Guide M0201AKG_uc
Page 6 © February 2021 CommScope, Inc.
CAP H Overview
CAP H Connectors and Status LED
The CAP H connectors and Status LED are described in the following sections:
• "Connectors and Status LED on Models with One Antenna" on page 6
• "Connectors and Status LED on Models with Two Antenna Connectors" on page 9.
Connectors and Status LED on Models with One Antenna
• Figure 2 shows the connectors on an AC version of the CAP H that has one antenna connector.
• Table 2 on page 7 maps the callouts in Figure 2 and Figure 3 on page 8 and describes the connectors and
STATUS LED.
• Figure 3 on page 8 shows the connectors on a DC version of the CAP H that has one antenna connector.
Figure 2. Location of Connectors and LED on AC Version with One Antenna Connector
Do not remove caps from any of the connectors until instructed to do so.
1
2
3
4
6
7
5
8