Installation Guide
Table Of Contents
- Table of Contents
- Document Overview
- Era System Overview
- CAP H Overview
- Safely Working with a CAP H
- Installing a CAP H
- Using the Status LED to Determine State of the CAP H
- Maintenance
- Contacting CommScope
M0201AKC CommScope Era
™
High Power Carrier Access Point Installation Guide — Preliminary
© April 2019 CommScope, Inc. Page 51
Maintenance
6 Do the following to remove the Fan Unit:
a Unscrew and disc
onnect the fan connector.
b Unscrew the
four Pan-head screws that secure the fan plate to the CAP H chassis.
c Pu
ll the Fan Unit from the CAP H chassis.
Fan connector
Pan-Head
screw
Pan-Head
screw
Pan-Head
screw
Pan-Head
screw
7 Do the following to install the new Fan Unit:
a I
nsert the new Fan Unit into the CAP H chassis.
b Use
the four Pan-head screws that you removed in step Step 6 to secure the new Fan Unit to the CAP H
chassis.
c C
onnect the fan connector.
d Re
place the Fan Unit cover that was removed in Step 4 and Step 5 on page 50.
8 Reconnect the CAP H to mains power and make sure it is powered on.