Installation Guide
Table Of Contents
- Table of Contents
- Document Overview
- Era System Overview
- CAP H Overview
- Safely Working with a CAP H
- Installing a CAP H
- Using the Status LED to Determine State of the CAP H
- Maintenance
- Contacting CommScope
M0201AKC CommScope Era
™
High Power Carrier Access Point Installation Guide — Preliminary
© April 2019 CommScope, Inc. Page 39
Installing a CAP H
Connect the Optical Fiber
1 Contact your local CommScope sales representative to obtain the following components, as required, for
this installation.
• Per
the installation plan, obtain either Single Mode Fiber (SMF) or Multi Mode Fiber (MMF) that is of
sufficient length to reach from the CAP H to a Classic CAN or TEN.
• Al
l CAP Hs ship with the required Optical OCTIS Kit (PN 7770612). If cascading a Secondary CAP H, a
second Optical OCTIS Kit is required. (CascadingofCAPHAPsisnotsupportedinthecurrent
softwareversion.)
• O
btain SFP+ Module pairs (one placed in the TEN and paired with another in the Classic CAN) that are
appropriate for this installation. Table 10 identifies the available SFP+ Modules and the maximum
range for
each.
Table 10. Supported SFP+ Modules
CommScope PN Description Maximum Range
7660511 SFP+, 10GBase-SRR, Multi Mode OM3 300m
OM4 400m
7680813 SFP+, 10GBase-LR, Single Mode 10km
7803247 SFP+, 10GBase CWDM-270 40km
7803249 SFP+, 10GBase CWDM-290 40km
7803291 SFP+, 10GBase CWDM-310 40km
7803293 SFP+, 10GBase CWDM-330 40km
7803295 SFP+, 10GBase CWDM-350 40km
7803298 SFP+, 10GBase CWDM-370 40km
7803900 SFP+, 10GBase CWDM-390 40km
7803902 SFP+, 10GBase CWDM-410 40km
7803904 SFP+, 10GBase CWDM-430 40km
7803906 SFP+, 10GBase CWDM-450 40km
7801330 SFP+, 10GBase CWDM-470 40km
7801340 SFP+, 10GBase CWDM-490 40km
7801342 SFP+, 10GBase CWDM-510 40km
7801344 SFP+, 10GBase CWDM-530 40km
7801360 SFP+, 10GBase CWDM-550 40km
7801363 SFP+, 10GBase CWDM-570 40km
7801365 SFP+, 10GBase CWDM-590 40km
7801367 SFP+, 10GBase CWDM-610 40km
• If connecting an external Ethernet device such as WiFi or IP camera, an Ethernet OCTIS Kit
(PN 7760652 RJ-45) and appropriate CAT cable for the proto
col to which the CAP H will connect.
(This model supports a 1000 BASE-T and 802.3at Class 3 Power over Cat6A Ethernet connection.)
– A
single CAP H can support one auxiliary Ethernet device.
– A
cascaded CAP H pair can support one auxiliary device.