Installation Guide
Table Of Contents
- Table of Contents
- Document Overview
- Era System Overview
- CAP H Overview
- Safely Working with a CAP H
- Installing a CAP H
- Using the Status LED to Determine State of the CAP H
- Maintenance
- Contacting CommScope
CommScope Era
™
High Power Carrier Access Point Installation Guide M0201AKC
Page 38 © April 2019 CommScope, Inc.
Installing a CAP H
2 Join the connectors and turn the coupling nut until the thread
grips.
3 Push in the connector until it clicks.
4 Fasten the coupling nut hand-tight. Do not turn the connector but
the coupling nut only.
5 Retain the cable connector with the counter wrench (A) and fasten
the coupling nut with the torque wrench (B) until the torque is
applied (torque wrench clicks).
Note that for angled antenna connectors you should use your
hand to retain the cable connector and fasten the coupling nut
with the torque wrench. Make sure only the coupling nut is
turned, not the cable connector.