Installation Guide
Table Of Contents
- Table of Contents
- Document Overview
- Era System Overview
- CAP H Overview
- Safely Working with a CAP H
- Installing a CAP H
- Using the Status LED to Determine State of the CAP H
- Maintenance
- Contacting CommScope
CommScope Era
™
High Power Carrier Access Point Installation Guide M0201AKC
Page 32 © April 2019 CommScope, Inc.
Installing a CAP H
Install the CAP H Cables
The following sections tell you how to cable the CAP H. Follow the procedures in the order in which they are
given.
Ground the CAP H
The CAP H must be grounded.
Do not use the grounding bolts to connect an external device.
1 C
onnect an earth-bonding cable to the grounding bolt connections on the outside of the CAP H chassis, as
shown in the graphic to the right.
• A
C versions will have one M8 bolt; see Figure 2 on page 6.
• DC
versions will have two M6 bolts; see Figure 5 on page 11.