Installation Guide
Table Of Contents
- Table of Contents
- Document Overview
- Era System Overview
- CAP H Overview
- Safely Working with a CAP H
- Installing a CAP H
- Using the Status LED to Determine State of the CAP H
- Maintenance
- Contacting CommScope
M0201AKC CommScope Era
™
High Power Carrier Access Point Installation Guide — Preliminary
© April 2019 CommScope, Inc. Page 27
Installing a CAP H
5 Do the following to mount the CAP H in the Wall Mount Bracket.
a Hang t
he CAP H in the upper bracket.
b Push
the CAP H into to the lower bracket (A), and then fasten it to the lower bracket using two M8x20
screws (B), split-lock washers (C) and flat washers (D) so that the flat washers are against the
mounting bracket; torque to 27 N-m.
A
B
D
C