Installation Guide
Manuals
Brands
Andrew Wireless System Manuals
Computers & Accessories
ERA repeater for cellular systems
11
12
13
14
15
16
17
18
19
20
Table Of Contents
Table of Contents
Document Overview
Document Revision History
Document Cautions and Notes
Abbreviations Used in this Guide
CommScope Part Numbers
Era System Overview
CAP H Overview
CAP H Connectors and Status LED
Connectors and Status LED on Models with One Antenna
Connectors and Status LED on Models with Two Antenna Connectors
CAP H Accessory Options
Mounting Kits
OCTIS Kits
Safely Working with a CAP H
RF Safety Cautions
Health and Safety Precautions
Property Damage Warnings
Guard Against Damage from Electro-Static Discharge
General Installation Safety Requirements
Compliance
Equipment Symbols Used / Compliance
Required Antenna Distances
Installing a CAP H
CAP H Installation and Cascade Rules
Prepare for Installation
Recommended Tools and Material
Unpack and Inspect the CAP H and Optional Accessories
Installation Cautions
Determine the Mounting Site
Wall Mounting a CAP H
Pole Mounting a CAP H
Install the CAP H Cables
Ground the CAP H
Connect the Antenna Cable
Clean the RF Cable Connectors
Assemble the Antenna Cable Connector
Connect the Optical Fiber
(Optional) Connect an Auxiliary Device
Connect the MAINS Power
Working Safely with MAINS Power
Connect the MAINS Power and Power on an AC CAP H
Connect the MAINS Power and Power on a DC CAP H
Using the Status LED to Determine State of the CAP H
Maintenance
Rules to Observe During Maintenance
Routine Maintenance of the CAP H
Replacing the Fan Unit
Cleaning the Heat Sink
Contacting CommScope
CMS Global Technical Support
Telephone Helplines
Online Support
Waste Electrical and Electronic Equipment Recycling
Hardware to Software Mapping Information
Mobility Solutions Technical Training
Accessing Era/ION-E Series User Documentation
1
2
3
6
5
7
8
4
CommScope Era
™
High Power Carrier Access Point Installation Guide
M0201AKC
Page 8
© April 2019 CommScope, Inc.
CAP H Overview
Figure 3.
Location of Connectors and Status LED on DC Version with One An
tenna Connector
1
...
...
10
11
12
13
14
...
...
60
