Installation Guide
Table Of Contents
- Table of Contents
- Document Overview
- Era System Overview
- CAP H Overview
- Safely Working with a CAP H
- Installing a CAP H
- Using the Status LED to Determine State of the CAP H
- Maintenance
- Contacting CommScope
CommScope Era
™
High Power Carrier Access Point Installation Guide M0201AKC
Page 6 © April 2019 CommScope, Inc.
CAP H Overview
CAP H Connectors and Status LED
The CAP H connectors and Status LED are described in the following sections:
• "Connectors and Status LED on Models with One Antenna" on page 6
• "Connectors and Status LED on Models with Two Antenna Connectors" on page 9.
Connectors and Status LED on Models with One Antenna
• Figure 2 shows the connectors on an AC version of the CAP H that has one antenna connector.
• Table 2 on page 7 maps the callouts in Figure 2 and Figure 3 on page 8 and describes the connectors and
STATUS LED.
• Figure 3 on page 8 shows the connectors on a DC version of the CAP H that has one antenna connector.
Do not remove caps from any of the connectors until instructed to do so.
1
2
3
4
6
7
5
8
Figure 2. Location of Connectors and LED on AC Version with One Antenna Connector